{
  "schema": "https://arpelier.com/schema/flow-1.0.json",
  "name": "Oxide window",
  "note": "Small geometry example: substrate, oxide, photoresist opening, oxide etch, resist strip. This is not a calibrated device model.",
  "domain": { "LX": 80, "LY": 80, "dx": 5, "dy": 5 },
  "gridResolution": 1,
  "masks": [
    {
      "id": "window", "name": "Oxide opening", "negpol": true,
      "domain": { "LX": 80, "LY": 80 },
      "data": { "objects": [
        { "type": "rect", "left": 20, "top": 20, "width": 40, "height": 40, "data": { "polarity": "positive" } }
      ] }
    }
  ],
  "processes": [
    {
      "id": "substrate", "kind": "SUBSTR", "material": 5, "substrateDoping": "p", "thickness": 30,
      "name": "p-Si substrate",
      "note": "Starts from p-type silicon, 30 nm of it under this small 80 × 80 nm window of the wafer. Every dimension in this example is a round illustrative value, not one taken from a source."
    },
    {
      "id": "oxide", "kind": "DEPO", "material": 18, "thickness": 20,
      "name": "Oxide film",
      "note": "Covers the whole surface with 20 nm of SiO2, the film the window is opened in. On a real line the film's thickness uniformity decides how evenly the later etch clears it across the wafer."
    },
    {
      "id": "photo", "kind": "PHOTO", "mask": "window", "thickness": 10,
      "name": "Window resist pattern",
      "note": "Coats 10 nm of photoresist and exposes the window mask, so the resist stays everywhere except the 40 × 40 nm square in the middle. The resist only has to outlast the oxide etch; a real resist would be far thicker than this geometric example needs."
    },
    {
      "id": "etch", "kind": "ETCH", "materialetch": { "18": 1 }, "materialetchSelectionMode": "exact", "thickness": 20,
      "name": "Oxide window etch",
      "note": "Removes the 20 nm of SiO2 left open in the window and stops on the silicon, since this etch removes only SiO2. On a real line a short over-etch makes sure the oxide clears everywhere while attacking the silicon below as little as possible; this model removes exactly the 20 nm."
    },
    {
      "id": "strip", "kind": "STRIP", "material": 24,
      "name": "Resist strip",
      "note": "Strips the remaining photoresist, leaving the 20 nm oxide with a 40 × 40 nm opening down to the silicon."
    }
  ]
}
